How to thermally insulate with cork sheets?

How to isolate with the Paulinkoibenta Bio system

In the case of departure from the walking surface, establish the altitude “ ZERO” starting at least 1-2 cm above this surface and mechanically fix the STARTING PROFILE with a perforated aluminum drip with a section suitable for the thickness of the slabs, inserting a 40-60 cm high sintered expanded polystyrene panel at the base for the plinth same thickness of the insulator that we will subsequently affix.

L’ anchoring of the insulating panels, laid staggered, will be achieved by applying adhesive mortar such as RASAKOLL MINERALE applied in strips along the edges and always in points in the center of the panel (in such a way that the glued contact surface is at least del 40 # 37) and l’ insertion (at least 6 per m2) of appropriate percussion dowels with steel core approved (with CE marking). The cork panels will be coated on site with a layer of adhesive mortar “ RASAKOLL MINERALE” spread with a toothed metal trowel over the entire surface, in which an alkali-resistant fiberglass net with rectangular meshes 3.80 x 4.14 mm and area mass > will be embedded; 150 g / m2, smoothing with a metal trowel. The reinforced layer will be completed with a subsequent smoothing to complete coverage of the mesh.

The laying of the reinforcement mesh “ RETE 160-A” it must be carried out in such a way that it is positioned in the upper third of the total leveling layer, providing for the overlapping of the edges of at least 10 cm and 15 cm near the edges, protected with relative edge protectors in pre-painted aluminum or PVC with mesh pre-assembled.